Drives | Mystic 1850mm + 1890mm (72,8" + 74,4") | 1 Pair

Well thought-out solutions for the highest demands
As with most of our boats, our Mystic C5000 is also equipped with suitable drives, depending on size and bodywork requirements.Thanks to their special, hydrodynamic profile, they ensure safe handling and additional stability - even at high speeds.

Our drives are made exclusively from high quality aluminium 7075. The black anodizing provides additional protection against corrosion. The drive shaft is made of V2A (stainless steel) and therefore suitable for usage in salt water as well. The plain bearings installed in the drives ensure high efficiency and low maintenance (compared to ball bearings). The thrust bearing washers are made of the best quality PEEK material. This material is much more durable than the often used PTFE, PF & Co.  
The angle of the drive is adjustable +/- 4°

Good to know!
A little trick helps to mark the holes at the rear. Place a white sheet of paper on the rudder pad and paint several times with a pencil over it. In this way, you "match" the exact contours of the holder. Now simply cut out the template, stick it to the hull with adhesive tape and drill the required holes.
We recommend to use Polymer glue for assembly.