Outboard Drive | Z-Drive | Outboard Engine

Developed on the basis of our Z-drive
The outboard has 4 ball bearings and hypoid toothed bevel gears for maximum performance and stability. The drive is intended for both left and right-hand rotation. Decisive here is therefore the direction of the motor used.

That fits!
Fits boats from 1,20m length (with double drive from 1,40m length) and electric motors like our Scorpion 5035 or other, similar models. To facilitate the setup, you can choose between 8mm and 10mm engine clutch in the selection menu.

Good to know!
Depending on the motor used, it may be necessary to shorten the motor shaft before installation. To do this, pack the motor airtight and then shorten the shaft. This will prevent the metal chips from damaging your engine. For a visually clean finish, we recommend our Power Tower hood. Please note that due to customs regulations the outboard motors are not greased before shipment and must therefore be lubricated with gear oil before use.
Please also note that the drive should only be used in water - therefore not in the dry state. Otherwise, the drive will not be sufficiently cooled and shaft seals may be damaged.