Outboard drive | Outboard design | 4,75mm (3/16")
Prices incl. VAT plus shipping costs
Preorder: Delivery time 21-28 Workdays
Outboard drive for your XCat 1050mm
This drive with outboard design was made as a Seven outboard drive (7 AB) look a like, However the assembly of the motors is inside of the hull. Why so? Because this way you have a much greater choice of suitable motors such as 3660, 4082, 4092 but also Scorpion 3026 as well as Scorpion 4035.
The drive comes with a plastic cover for the perfect outboard drive look. The adapter plate as well as steering lever are made of high quality aluminium.
Good to know
For clean and easy hull passage we reocmmend to use our article 1070-1 (see bundle) A little trick helps to mark the holes at the rear. Place a white sheet of paper on the rudder pad and paint several times with a pencil over it. In this way, you "match" the exact contours of the holder. Now simply cut out the template, stick it to the hull with adhesive tape and drill the required holes.
This drive was made for the XCat 1050mm especially. Of course you may also use this drive with any hull you like between 100-115cm. Further fitting parts are shown below.
> Do you have any questions concerning this product?
|Prop shaft:||4,75mm (3/16") suitable for 4,75mm (3/16") flex shaft|
How to remove the propshaft for assembly of the flex shaft?
- Take off the hatch
- Release the below allen screws
- Loosen the stud screw and the greasing nipple
- Pull out the bearing sleeve to the rear
- Take off the Drive Dog from the prop shaft
- Release the prop shaft by pulling it out to the front
No minimum order quantity. Check shippment costs here.
We do accept payment by paypal and bank transfer. Credit card payment through paypal is also accepted.
Queries? Please contact us anytime by using our contact form.