Scater | 1460mm (57,48")

Hommage to original skater class P1
As in the original this monoboot is suitable for the construction with two drives. The skater convinces with a very stable and calm handling on straight line. Curves must be done with slow speed as all mono boats with steps.

That fits!
The setup can be done either as electric and as a gasolinbe speedboat. Suitable engines would be for example, the Zenoah G320 PUM in use with a gearbox. For the electrical setup we recommend two Scorpion 5035 (10S) and a 240A controller.

Good to know!
The center of gravity of the skater is at 26-30% from the transom.

The little difference
This hull is available in different versions. In general, all of our hulls are manufactured using the sandwich "wet in wet" process (1 layer of 100er GFK + 1 layer of 160er GFK + optionally 1 layer of C-AFK or CFK + 1 layer of 100er GFK). In this way, the upper and lower part connect optimally and, unlike in vacuum process, there is no weak point on the seam edge of the boat. Which version suits you best depends on what plans you have with your power boat. GFK hulls are stable and suitable for normal speed up to 130Km/h. For higher speeds, we recommend using the C-AFK (very stable, firm, heavier than GFK) or CFK (very stable, flexible and lighter than C-AFK) version.