Lizard Xtreme XL | 1430mm (56,3")

Your wish is our command
The answer to your consistently very positive feedback on our Lizard Xtreme and the associated desire to offer this hull enlarged. The Lizard Xtreme XL is now 1430mm long and therefore suitable for single and double drives. Like its smaller relative, the Lizard Xtreme XL is suitable for any type of water. FSR drivers head up, because the Lizard Xtreme XL is also intended for use for FSR 027 and 35 races. Even when it comes to assembly, the imagination has no limits.

That fits!
For a better overview a few design ideas.
Electro construction - for example Scorpion 5035 or SSS 5692 in use with NXT, Z-drives or Trimax and rudder (2 x 12S). With an ultra-lightweight construction, the use of Mercury Outboard drives is also possible.
Gasoline: The Zenoah 32-35ccm or RCMK 2 cylinder engines are suitable for use as direct drive or with gearbox

Good to know!
The center of gravity of Lizard Xtreme is 26-30%. Based on the original racing boats, the setup is recommended with trim tabs. For more lift, it is possible to attach floating noodles to the hull itself.

The little difference
This hull is available in different versions. In general, all of our hulls are manufactured using the sandwich "wet in wet" process (1 layer of 100er GFK + 1 layer of 160er GFK + optionally 1 layer of C-AFK or CFK + 1 layer of 100er GFK). In this way, the upper and lower part connect optimally and, unlike in vacuum process, there is no weak point on the seam edge of the boat. Which version suits you best depends on what plans you have with your power boat. GFK hulls are stable and suitable for normal speed up to 130Km/h. For higher speeds, we recommend using the C-AFK (very stable, firm, heavier than GFK) or CFK (very stable, flexible and lighter than C-AFK) version.