Jetsprint | Jetboat | 1110mm (43,7")

Free interpretation of the Australian and New Zealand jetboats
These drive there in artificially created slalom channels with very high speeds. Our jetsprint can therefore be constructed with a jet propulsion system. This offers the opportunity to drive even when the water level is shallow. Furthermore, jetboats are characterized by a very high maneuverability and an extremely high fun factor.

That fits
For this jet boat we recommend the construction with our Jet 52 and either a 22-29cc engine, the Scorpion 5035 or a SSS motor of the 56er series (up to 10S) and a 300A ESC.

Good to know!
Because of the high suction, the center of gravity is about 40% from the transom. Further matching accessories can be found below in the section "That fits".

The little difference
This hull is available in different versions. In general, all of our hulls are manufactured using the sandwich "wet in wet" process (1 layer of 100er GFK + 1 layer of 160er GFK + optionally 1 layer of C-AFK or CFK + 1 layer of 100er GFK). In this way, the upper and lower part connect optimally and, unlike in vacuum process, there is no weak point on the seam edge of the boat. Which version suits you best depends on what plans you have with your power boat. GFK hulls are stable and suitable for normal speed up to 130Km/h. For higher speeds, we recommend using the C-AFK (very stable, firm, heavier than GFK) or CFK (very stable, flexible and lighter than C-AFK) version.